ECU Master Digital Ecu Tuner III

Digital ECU Tuner 3 is used to modify signals from sensors to ECU (Electronic Control Unit). Thanks to this function, it is possible to modify such engine parameters as the fuel dose, ignition angle, boost controlling or extra injectors. Additionally, some of the device’s functions help to tune the car thanks to the advanced datalogger and the road dyno, which can measure the power and the vehicle’s torque in the real conditions (a car driving on the road).

The device’s characteristics
• 4 independent tables 16x 16 (fuel table, two PWM tables, ignition table),
• 8 correction tables 16 x 1,
• 2 independently switching table sets,
• an option to modify a single analog signal,
• 4 analog inputs,
• built in Data Flash, which enables the signals to log in without plugging in the laptop,
• measurement of the power supply voltage,
• an option to modify a signal from the frequency based MAP and MAF sensors (in range of 17Hz-4kHz),
• supporting the ignition signal with using: variable reluctant sensors, Hall’s, optical sensors and signals,
which control the ignition module. The device services both the single ended and differential signals.
• support of many ignition types: 60-2, 36-2, 36-1, 18-1-18-1, EDIS, Multitooth, Ignition Modules, Subaru
GT, Honda D Series,
• an option of boost control using 3 way solenoid valves,
• servicing of 4 high-Z injectors (batch fire system),
• an option for a direct modification of the injection time for the batch fire systems,
• ON/ OFF type parametric output,
• automatic conversion from MAP to MAF using auto learning system,
• launch control,
• road dyno,
• an option to calibrate any analog sensors, which enables the analog values to be displayed in their real
values ( for example, a signal from MAP sensor in bars, a signal from a WBO meter as AFR, etc.) ,
• an option for a free firmware upgrade ( new ignition modes, additional functions),
• USB communication port.